JYB WATER SOLUTIONS LLC provides end-to-end water system expertise. Whatever your source water, target chemistry, or flow requirement, we supply the engineering, equipment, and care to keep your treatment train running at its best.
Good treatment begins long before a single pipe is turned. Our engineers start with a full review of your raw water, including hardness, iron, manganese, bacteria, turbidity, and any seasonal swings that could change chemistry across the year. We combine those findings with your required quality and flow to size every component of the train.
The design phase covers vessel selection, media and membrane loading, pump curves, contact time, and waste routing. We model the hydraulics so each stage receives exactly the flow and pressure it needs and so flushing and backwash are effective without waste. Every drawing we deliver is intended to be built, maintained, and expanded with minimum disruption to your process.
Most contaminants are removed long before the final drop reaches the tap. We install multimedia, green sand, and carbon filtration that protect downstream equipment and extend the life of every expensive component. Your water is clarified at the front of the train, which keeps membranes cleaner and reduces energy demand.
For demanding applications we design reverse osmosis skids tuned to your feed water. We balance recovery, flux, and concentrate so the membrane runs within its comfort zone. The system recovers more clean product water and produces a consistent stream your facility can rely on around the clock.
When you need disinfection without taste, odor, or chemical by-products, ultraviolet is the answer. We size UV chambers to deliver a validated dose against your target organisms, including bacteria and viruses, with enough margin for real flow variation and lamp aging.
Every installation pairs the chamber with flow control and dose monitoring so performance is proven rather than assumed. Operators can see lamp status and intensity at a glance, and our predictive-maintenance guidance tells you exactly when a lamp or sleeve deserves attention. The result is safe water energy-efficiently and continuously.
A treatment train is only as strong as the hydraulics that move water through it. We engineer transfer pumps, pressure boosters, and recirculation loops sized to actual duty so flow never starves a filter or starves a membrane. Our manifolds and header arrays balance flow across parallel vessels and allow clean isolation for service.
Valves are placed where operators need them, and pressure gauges live on the primary runs so the system is easy to read. This attention to layout cuts commissioning time, lowers pressure loss, and makes future expansion far simpler.
You cannot manage what you cannot measure. We install instruments that track conductivity, turbidity, flow, pressure, and oxidation-reduction potential at the points where they matter most. Readings stream to a central display and alarm when a value moves outside your set range, so a small deviation gets corrected before it becomes a quality failure.
Sensors also log a full history of your water, which supports documentation, troubleshooting, and audits. Our monitoring brings transparency to your entire plant and gives your team confidence in every cycle of the system.
Treated water depends on disciplined routine care. Our service agreements cover membrane audits, chemical cleaning, media exchange, lamp and sleeve renewal, seal and bearing checks, and instrument calibration on a schedule matched to your operating hours. Well-run maintenance prevents the small drift that quietly drives up cost and risk.
Each visit ends with a clear report on pressures, flows, and water quality so you can see exactly how your system is performing. Our goal is a plant that simply stays reliable, season after season, with surprises kept to a minimum.
We review your source water, current equipment, and target quality, then confirm flow and chemistry goals with your team.
Engineers produce the treatment train layout, vessel and component sizing, hydraulics, and a clear equipment schedule.
Skids are assembled, piping and manifolds are connected, and pumps, controls, and monitoring are brought online together.
We start up the system, verify flow, dose, and water quality, calibrate instruments, and train your operators on every task.
A maintenance program, remote monitoring, and responsive field support keep your plant dependable for years to come.
Contact JYB WATER SOLUTIONS LLC with your source details and target quality and our engineers will outline the right treatment train for your facility in Orem and across the United States.
Request an Assessment